Knoll Systems HT200 - Manual (Page 14)

2) Press the POWER ON button on the remote control or the POWER button on top of
the unit to turn on the unit.
The POWER indicator on top of the unit turns to green and start blinking. It will take one
minute for the projector to be ready to use. Wait until the indicator stops blinking and lights
steadily in green.
Note: While the POWER indicator is blinking, the unit doesn't turn off even if you press the
POWER OFF button on the remote control or the POWER button on the unit.
Tip: If you set "AUTO START" to "ON" in the menu (see page 20), the projector will turn on
automatically after setting the POWER switch to on in step 1.
3) Turn on the connected source (computer, VCR, DVD player, etc.).
If you use a video component, start playback for screen/image adjustment.
4) Press VIDEO, S-VIDEO, or RGB to select the input source.
You can also select the input source with the menu operation (see page 18).
Notes
• If the blue, black or focus pattern screen (the background type differs depending on the
"BACKGROUND" setting. See page 19.) is projected, check the following:
- Is the source is properly connected to the unit?
- Is the source component or computer turned on?
- Is the video signals are coming to the projector?
• The video resolution of the connected computer can be changed. See page 16.
5) Adjust the position and height of the unit.
Move the unit to the position where the
projected image is horizontally centered
to the screen.
• When the projected image is offset
horizontally
Adjust the position of the unit so that
the unit is square to the screen
• When the projected image is offset
vertically
Adjust the height balance of the unit
with the adjusters.
Using the adjusters to adjust the
height balance
There are two front adjusters and a rear adjuster.
To lower the position of the screen, pull out the folded leg of the rear adjuster.
For the front adjusters, rotate each adjuster until the unit is vertically parallel to the screen.
6) Adjust the image size with the zoom ring lever, then adjust the focus with the focus ring.
14