Knoll Systems HT200 - Manual (Page 13)

Connecting the remote mouse receiver to an IBM PC/AT computer
Connect the IBM/Mac connector on the remote mouse receiver and PC's mouse port with the
supplied serial cable.
Connecting the remote mouse receiver to an IBM PS/2 or Macintosh computer
Connect the supplied serial cable to the IBM/Mac connector on the remote mouse receiver.
Connect the supplied mouse adapter to the other end of the serial cable and the computer mouse
port. Note that two types of mouse adapters are supplied; one is for IBM PS/2 and the other is for
Macintosh.
Operation
Using the Projector
Before starting
• Remove the lens cap from the lens.
Please retain it because it must be
replaced after use.
• Don't use the Projector in a bright room
and don't expose the screen to direct
sunlight or other strong light sources.
1) Connect the supplied power cable to the
unit, then to the wall outlet (the mains).
Press the "l" side of the POWER switch
(main power) on the back of the unit.
The POWER indicator on top of the
unit lights in amber.
The POWER indicator on top of the
unit lights in amber.
13