Knoll Systems HT200 - Manual (Page 5)

Remote Control
Inserting the
batteries
1) Press firmly
and slide the
battery cover
off.
2) Insert the
supplied two
batteries (size
AA/R6).
Ensure that the
polarities (+
and -_) of the
batteries are
aligned
correctly.
Always replace
batteries with
fresh alkaline
type.
3) Slip the cover
back over the
batteries until it
snaps into
place.
Notes
• If the remote
control gets wet,
wipe it dry
immediately.
• Avoid excessive
heat and
humidity.
• If you will not be using the remote control for a long time, remove the batteries.
• Do not mix new and old or different types of batteries.
• There are operations that can only be carried out by remote control. Handle the remote control
carefully.
Remote control effective range
Each side of the projector has a remote sensor. The controllable range is 50 degrees horizontally
and 30 degrees vertically relative to a line that is at a right angle to the remote sensor. And the
distance between the point of the remote control and remote sensor must be no more than four to
five meters (about 15’).
5