Knoll Systems HT200 - Manual (Page 25)

The following three types of gamma modes can be selected according to your
preferences:
• NORMAL,
• NATURAL 1, or
• NATURAL 2.
8. Press L-CLICK.
9. Press the cursor up or down key to select “INPUT MODE,” then press the cursor +/- key to
select the input mode.
If the input source is RGB, refer to “Setting INPUT MODE to YcbCr” on page 20.
If the input source is VIDEO or S-VIDEO, the following two types can be selected:
• GRAPHICS for displaying a graphic image, or
• TEXT for displaying a text image such as the image from the document camera.
10. Press L-CLICK
11. Press the cursor up or down key to select “WHITE PICTURE,” then press the cursor +/- key
to select the white picture mode.
The following two types can be selected:
• NORMAL, or
• QUIET to reduce brightness for better color expression,
12. Press L-CLICK
Selecting the wide screen display
1. Carry out the steps 1 to 6 above.
2. Press the cursor up or down key to select “DISPLAY MODE,” then press the cursor +/- key
to select “WIDE” for wide screen display or “NORMAL” for normal screen display.
Activating the power saving function
This function operates only with an RGB input source.
If the input signals from the RGB IN connector go down for more than five minutes, the projector
will automatically turn off and enter the standby mode.
1. Press MENU to display the main menu.
2. Press the cursor up or down key to select “POWER MENU.”
3. Press L-CLICK to display the POWER MENU.
4. Press the cursor up or down key to select “POWER OFF,” then press the cursor + key to select
“ON” to activate the power saving function.
To deactivate the function, set “POWER OFF” to “OFF” by pressing the cursor – key.
Activating the on-screen function
If you activate the on-screen function,
• The input source “VIDEO,” “S-VIDEO,” or “RGB” will be displayed for three seconds
when you have selected the input source with the remote control (see page 13), and
• The message “POWER OFF/ENTER” will be displayed on the screen when you press the
projector POWER button. If “DISPLAY” is set to “ON” this prevents the projector from
being turned off accidentally.
1. Press MENU to display the main menu.
2. Press the cursor up or down key to select “SETTING MENU.”
3. Press L-CLICK to display the SETTING MENU.
4. Press the cursor up or down key to select “DISPLAY,” then press the cursor + key to select
“ON” to activate the on-screen function.
To deactivate the function, set “DISPLAY” to “OFF” by pressing the cursor – key.
25