Kenwood NEXEDGE NX-200 - Manual (Page 37)

28
p
riority
S
cAn
A Priority channel must be programmed in order for Priority
Scan to function.
When using a single Priority channel, the transceiver will
automatically change to the Priority channel when a call is
received on it, even if a call is being received on a normal
channel.
When using dual Priority channels, Priority channel  is given
precedence over Priority channel 2. So, if a call is received on
Priority channel  while a call is already on Priority
channel 2, the transceiver will automatically change to Priority
channel .
• “ ” appears on the display when the channel is Priority channel ,
“ ” appears when the channel is Priority channel 2, and “ ”
appears when the channel is both Priority channel  and 2.
S
cAn
r
evert
The Scan Revert channel is the channel selected when you
press the PTT switch to transmit during scan. Your dealer can
program one of the following Scan Revert channels:
•
Last Called + Selected: The last channel on which you
received a call is assigned as the new revert channel. If the
channel has been changed, the newly selected channel is
assigned as the new revert channel.
• Selected: The last channel selected is assigned as the
new revert channel.
• Selected + Talkback: If the channel has been changed,
the newly selected channel is assigned as the new revert
channel. The transceiver “talks back” on the current
channel.
• Priority 1/ Priority 2: If your dealer has programmed a
Priority channel (either Priority  or Priority 2), this channel
is the revert zone and channel.