Kenwood NEXEDGE NX-200 - Manual (Page 41)

32
3 In Selcall mode, press the / keys to select the ID
of the station you want to call.
• If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using the / keys.
When using the / keys, cycle through the digits
to select a digit, then press the key to set the digit and
move the cursor to the right. Repeat this process until the
entire ID is entered.
4 Press the key to enter Status mode.
5 Press the / keys to select the status ID you want
to transmit.
• If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using the / keys.
When using the / keys, cycle through the digits to
select a digit, then press the key to set the digit and
move the cursor to the right. Repeat this process until the
entire ID is entered.
6 Press the PTT switch or the Side 2 key to initiate the
Status call.
• “<<COMPLETE>>” is displayed when the call has been
successfully transmitted.
■
Receiving
The icon will flash and a calling ID or text message will
appear when a Status call is received. Also, if the Vibrator
function has been activated {page 40}, the transceiver will
vibrate when a Status call is received.
Press any key to return to normal operation.
■
Reviewing Messages in the Stack Memory
1 Press the key programmed as Stack, or press and hold
the key programmed as Selcall, Status, or Selcall +
Status to enter Stack mode.
• The last received message is displayed with the message
number.