Konica Minolta 7020 - Manual (Page 22)

22
6. Before Copying
6.1 Weekly Timer
The copier provides a timer function that can be activated by the
operator. In this case, please do not switch the unit on and off at
the main power switch; the machine turns on and off automatically.
Timer Interrupt
– Press the Power switch on the left side of the panel.
– A four digit timer interrupt password is needed if the operator
has installed a password. Enter the code and touch START.
– Now specify the actual ON-time period; hours one-digit and
minutes two-digit numbers (e.g. 2 h, 05 minutes). Confirm
each input by pressing START.
– After the specified period, the system will automatically go off
again.
6.2 User Password / Electronic Key Counter (EKC)
The message on the screen instructs you to
enter a user password.
This unit has an integrated electronic key counter, which mana-
ges up to 128 user accounts. Copies can be allocated to users,
accounts or projects, if the key operator has activated this func-
tion. A copy limit can be allocated to each counter.
If the electronic key counter is activated in this unit, a user pass-
word has to be entered to access the machine. Please contact
your key operator, if you need a password or can‘t remember
your allocated password.
Password Access:
– After switching on the system, a request to enter a password is
displayed on the screen.
– Enter your 5-digit code over the keypad, and press START.
– If you hit a wrong key, still enter 5 digits in total, and then press
START. Now repeat the procedure with the correct code.
– The number of copies made as well as the copy limit for this
counter are now displayed for a moment.
– If the copy limit has been reached for any password, the
system will not produce any further copies under this code.
Depending on how the copier is adjusted, a copy job in
progress can either be completed or will be interrupted.
Please contact the operator if a timer
interrupt password is needed or a change
of the ON/OFF times is required.