Konica Minolta 7020 - Manual (Page 37)

37
9. Special Functions
9.1.7 Frame / Fold Erasure
This function helps to avoid dark shadows, which appear when
copying 3-dimensional originals, e.g. books. A specified area
around the original and in the centerfold can be erased.
You can specify a frame erasure width between 1 and 15 mm
and a fold erasure width between 1 and 30 mm.
– Select the desired function. Both functions can be combined.
– Use the arrows to adjust the frame and/or fold erasure width.
Dark areas around the original are automatically erased. With
this function, the RADF
* is not available and has to remain open.
– Position the original on the platen glas.
– For duplex copying in this mode, you have to select the Store
Mode and scan your originals.
– An A4 size copy is produced; but you can select a different size
if required.
Advice:
The factory setting for this function is, that black areas are erased
along straight lines. The technical service can also adjust the
function to erase the black areas exactly along the contours of
the originals, e.g. objects.
9.1.6 Non Image Area Erase
– Select Verti./horiz., if you want to repeat a portion of an ori-
ginal. Use the arrows to specify the width and the height of
the original portion. Both values can range from 10 mm to
150 mm.
– Press Repeat to specify the number of repeats on the copy (2,
4 or 8 times). The repeated part of the original will not be
reduced. Its size depends on the number of repetitions.
– Position the original on the platen glas. The specified area is
measured from left to right and from top to bottom.
– An A4 size copy is produced; but you can select a different
size if required.