Konica Minolta 7020 - Manual (Page 30)

30
8.1 Job Programming / Reserve Mode
This section provides information on further basic copying
functions, which this system makes available.
While a copy job is being processed, you can make all selections
for the next job. Up to four copy jobs can be programmed.
– Press RESERVE. You can only call up this screen, while a copy
job is being processed.
– Make all required selections for the next job. Job Memory
settings cannot be recalled in Reserve mode.
– Insert your originals and press START. Originals will be
scanned and the Basic screen appears automatically.
– For further job programming press RESERVE again.
– The new copy job will be started automatically, once the
previous job is completed.
– Press JOB LIST to call up a list of pre-programmed jobs (see
below).
– If a problem occurs in the job being processed, in place of the
SETTING key another key will appear, e.g. ADD PAPER or
JAM. If this happens, press the corresponding key and follow
the instructions.
8. Other Basic Functions
This screen allows to check if all required settings have been
made; and in order to check a correct copy result, you have the
option to print a single sample copy without deletion of the
image memory afterwards.
– Press the CHECK key on the operating panel to call up a
screen which displays all settings made for the next copy job.
– If originals are inserted in the RADF * or have been scanned, a
sample set of copies can be generated. Press PROOF COPY for
a set of copies. The display now indicates, which previously
made settings can still be adjusted.
– If you do not need to make any adjustments, press START. In
this case the sample copy set will be counted for the total set
quantity.
– If the sample copy is no good and you want to start again,
press the STOP/CLEAR key on the panel to delete the image
memory.
8.2 Check Screen / Proof Copy
This screen is displayed after a sample copy
was printed; the star mark indicates the
selections, to which changes can be made.
Advice:
The scanned originals will only remain in the image memory after
the printing of a sample copy, if the copy quantity setting is more
than 1.
* Option