Konica Minolta 7020 - Manual (Page 6)

6
1. Advice on Installation and User Safety
1.1 Safety Warnings
Care Advice:
One precondition for a good copy quality
is a clean platen glass! We suggest to
clean the platen glass and the underside
of the doucment feeder daily with a clean
soft, possibly damp cloth or the special
Konica cleaning liquid. Never use volatile
or corrosive cleaners or solvents with this
equipment!
Dear User,
The following concerns the safe use of your new equipment.
Please take the time to read the following precautions carefully.
1. ATTENTION: While in use, a high voltage is generated inside
the equipment. Do not touch to avoid electrical shock!
2. Do not attempt to repair any parts of this equipment. All
repairs must be carried out exclusively by approved Konica
service technicians.
3. While in use, some parts inside the unit get very hot. To avoid
getting burned, follow instructions carefully when clearing
paper jams and only touch designated parts.
4. In case of liquid running into the unit, immediately switch off
the equipment, disconnect from the mains and inform your
Konica service.
5. To disconnect the unit from the mains, pull the plug from the
socket, which has to be located close to the equipment and
must not be obstructed at any time!
6. While toner is not hazardous to your health, it should be kept
out of reach of children. If toner is inhaled, swallowed or gets
into contact with the eye, consult your doctor.
7. If the equipment has to be opened, only the green knobs and
handles should be touched.
8. Before switching on the equipment, always ensure that the
unit is securely closed.
9. This equipment is not to be confused with shelves or other
office furniture. Do not obstruct the top of the unit with any
items but keep free at all times.
10. Avoid dropping anything into the unit (e.g. paper clips,
staples or else).
11. The touch screen of the operating panel is protected with a
thin glass. Only make function selections with your fingertips,
and avoid pressing on the display with hard or pointed items
(e.g. pens).
12. Do not load stapled or folded paper into the document
feeder, the paper trays or the sheet bypass.