Kathrein UFD 570/S - Manual (Page 46)

Installation
46
Pay attention to the help
information on the
individual menu items
you can obtain by
pressing the

button!
After pressing the

or

button, an on-screen display appears
asking whether you wish to add the network?
Confirm by pressing

.
The following message appears:
You can now use the

,

and

or

buttons to make the
entry corresponding to your receiving system in the corresponding
positions and exit the menu by pressing

3x. The new station data
are stored simultaneously.
Under "Operation" enter whether your active antenna is to receive its
power supply from the receiver.
Under "Standby" enter whether the power supply is to be switched off
in receiver standby.
To enter network names
Set the bar cursor in the required network position and press

. Set
the bar on the name, the first letter is marked. You can now change
the network name with the aid of the number buttons. The procedure
is described in the Section "Operating Information".
To remove a network
To remove a network, go to "Network configuration", move the cursor
bar with the

or

buttons and press

or

. You will now be
asked whether you wish to remove the network and you can confirm
by pressing

or cancel with

.