Kenwood DV-5700 - Manual (Page 49)

V
arious Setups
49
Chapter 6: Various Setups
"TV Mode" Setting
When the connected TV has a 4:3 aspect ratio while the
played software is recorded in widescreen video, the
mode of TV screen display can be selected.
At the factory, the player has been set to "Letterbox".
Setting items
" " : Select to return to the previous screen.
"Pan & Scan" : Select to play widescreen software
with pan & scan specification on a pan & scan
screen (screen with the left and/or right edges cut
off). When widescreen software without pan & scan
specification is played with this setting, it will be
reproduced in the Letterbox screen mode.
"Letterbox" : Widescreen software without pan &
scan specification is reproduced in the Letterbox
screen (screen with black bands on the top and
bottom).
"TV Aspect" Setting
If the connected TV is a widescreen TV, set the aspect
ratio (the ration between the horizontal and vertical sizes
of TV screen) of the player output to 16:9.
The player has been set to a the conventional aspect ratio
of "4:3" before it was shipped from the factory.
Setting items
" " : Select to return to the previous screen.
"4 : 3" : Select when the connected TV uses the
conventional aspect ratio of 4:3.
"16 : 9" : Select when the connected TV uses the
wide-screen aspect ratio of 16:9. Widescreen video
will be reproduced in full screen. (Set the screen
mode of the TV to the full mode.)
Operation procedure
1. Set the mode switch of the joystick remote to the
Purple position.
2. While the player is in stop mode, press
SET UP
1
to display
the "MAIN" menu of "SET UP MENU".
3. Press ENTER to open the setup screen.
4. In the setup menu, select "TV Aspect" by tilting the
joystick up or down and press ENTER .
7 16:9
7 4:3
7
OSD Position
On Screen Message
IPB Display
TV Aspect
TV Mode
TV Monitor Type
DVD VIDEO Mode
Rating
5. Select an aspect ratio by tilting the joystick up or
down, then press ENTER to enter the selection in
memory.