Kenwood DV-5700 - Manual (Page 66)

V
arious Setups
66
Chapter 6: Various Setups
5. Select "On" or "Off" by tilting the joystick up or down,
then press ENTER to enter the selection in memory.
"NTSC
= PAL" Setting
(For Europe and U.K.)
This setting makes it possible to play an NTSC-format
disc by converting signal into PAL format. Select "On"
when it is required to convert NTSC-format discs into
PAL signals.
Setting items
" " : Select to return to the previous screen.
"On" : Select to enable conversion from NTSC to PAL.
"Off" : Select to disable conversion from NTSC to
PAL.
Operation procedure
1. Set the mode switch of the joystick remote to the
Purple position.
2. While the player is in stop mode, press
SET UP
1 and tilt
the joystick up or down to display the "VISUAL"
menu of "SET UP MENU".
3. Press ENTER to open the setup screen.
4. In the setup menu, select "NTSC = PAL" by tilting
the joystick up or down and press ENTER .
7 Off
7 On
7
Disc Menu Language
Audio Language
Subtitle Language
Still Mode
FL Mode
SCART Output Select
NTSC = PAL
Player Menu Language
"SCART Output Select" Setting
(For Europe and U.K.)
This setting makes it possible to select the output signals
from the TV SCART connector of the player. (The VCR
SCART connector always outputs composite video
signals so its output signals cannot be selected.)
When the "RGB" output signals are selected with this
setting, the COMPONENT VIDEO OUTPUT jacks of the
player do not output any video signal.
At the factory, the TV SCART connector output signals
of the player has been set to "Composite".
Setting items
" " : Select to return to the previous screen.
"Composite" : Select to output composite video
signal.
"S Video" : Select to output S Video signals.
"RGB" : Select to output RGB signals.