Kenwood DV-5700 - Manual (Page 73)

Other Information
73
Chapter 7: Other Information
Remote control with the joystick remote is
impossible.
¶ The batteries are exhausted.
¶ The controller position is too apart from the remote
sensor, the control angle is deviated or there is an
obstacle between the remote and remote sensor.9
¶ The mode switch is not set to the proper position.
& to *
An inhibition icon is displayed and no operation is
accepted.
¶ The operations of certain DVDs and VCDs are restricted
by the intention of the software producers. Such discs
should be operated in accordance with the software.
Operations may also be restricted depending on the
player status.
DVD playback cannot be stopped by pressing the
STOP button.
¶ With certain DVDs, the inhibition icon is displayed
and playback cannot be stopped even when the 7
button is pressed. In this case, press the DISC SKIP
button to select another disc then press the
7 button
to stop playback.
If there is only one disc in the tray, open the tray, place
another disc, close the tray, press the DISC SKIP
button to select the second disc, then press the
7
button to stop playback.
The player display shows nothing.
¶ The player display is set to "FL OFF".
ˇ
Error code "E0102" is shown in the display and no
operation is accepted.
¶ Up to 5 discs can be placed in the tray of the player.
If you set a 6th disc by rotating the tray manually during
playback while 5 discs have already been placed in
the player, the player detects an error and the display
shows error code "E0102" at the moment you attempt
close the tray.
In this case, turn the player off, remove one of the discs,
then turn the player on again.
When an error code ("E" and 4 digits) is displayed in
other cases, always turn the player off then on again.
If the error code does not disappear after this, press
the POWER button while holding the 7 on the player
depressed. When the display shows "INIT OK!", turn
the player on again.
∏
If the error code still remains in the display, note the
error code and consult your dealer or local KENWOOD
for servicing.
The display shows "LOCKED" and no operation is
accepted.
¶ When the display shows "LOCKED" and the player
cannot be set to the standby mode or the disc tray
cannot be opened, perform the following procedure.
While holding the 7 button on the player main
unit, press
POWER
on the joystick remote.
The COMPONENT VIDEO OUTPUT jacks of the
player do not output video signals.
¶ When "RGB" is set in the "SCART Output Select"
setting, the COMPONENT VIDEO OUTPUT jacks
of the player do not output video signals.
Á
A MP3 disc cannot be played back.
¶ Certain MP3 discs are unplayable on this player.
An erroneous character is displayed in the title
display.
¶ The displayed characters may become erroneous if the
disc has been created on a PC, etc.