Digital audio dts" setting, Various setups, Operation procedure 1 – Kenwood DV-5700 User Manual
Page 55
V
arious Setups
55
Chapter 6: Various Setups
Operation procedure
1.
Set the mode switch of the joystick remote to the
Purple position.
2.
While the player is in stop mode, press
SET UP
1
and tilt
the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3.
Press
ENTER
to open the setup menu.
4.
In the setup menu, select "Digital Audio Dolby
Digital" by tilting the joystick up or down and press
ENTER
.
7
Bitstream
7
PCM
7
Digital Audio
Dolby Digital
Speaker Setting (Custom)
Speaker Setting (Quick)
Audio During Search
Dynamic Range Control
Audio Filter
DTS
MPEG
PCM Down Conversion
5.
Select the audio output by tilting the joystick up or
down, and press
ENTER
to enter the selection in
memory.
"Digital Audio DTS" Setting
When a DVD or DTS-CD recorded in DTS is played, this
setting makes it possible to select the audio signal output
from the digital output connector.
At the factory, the player has been set to "Bitstream" to
enable digital connection to an AV amplifier with built-
in DTS decoder. For the nonexistent decoders, set the
"Digital Audio" setting to "PCM".
Setting items
"
" : Select to return to the previous screen.
"Bitstream" : The signal is output as a bitstream.
Select when connecting a component containing
DTS decoder.
"PCM" : The signal is converted onto 48 kHz (2CH.)
PCM signal before being output. Select when
connecting a component without DTS decoder.
Operation procedure
1.
Set the mode switch of the joystick remote to the
Purple position.
2.
While the player is in stop mode, press
SET UP
1
and tilt
the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3.
Press
ENTER
to open the setup screen.
4.
In the setup menu, select "Digital Audio DTS" by
tilting the joystick up or down and press
ENTER
.
7
7
Bitstream
7
PCM
Digital Audio
Dolby Digital
Speaker Setting (Custom)
Speaker Setting (Quick)
Audio During Search
Dynamic Range Control
Audio Filter
DTS
MPEG
PCM Down Conversion
5.
Select the audio output by tilting the joystick up or
down, and press
ENTER
to enter the selection in
memory.