Kyocera KM-3650w - Manual (Page 25)

Chapter 2 Basic Operations 2-8
9. Slide the Cutter Knob (12) fully from one side to
another side to cut the leading edge.
Remove the paper portion after cutting.
10. Rewind the roll paper a little to place the leading edge as the following photo.
11. Close the Roll Deck (2) finally.
Place the leading
edge here.
2
12
NOTE
Slide the Cutter Knob completely until stopped at the end, or a paper jam occurs.
NOTE
Make sure to close the Roll Deck firmly until locked at the correct position.
A paper jam may occur if not locked firmly.