Kyocera KM-3650w - Manual (Page 37)

Chapter 3 Error Correction 3-4
4. Slide the Cutter Knob (5) fully from one side to
another side to cut the leading edge.
Remove the paper portion after cutting.
5. Rewind the roll paper a little to place the leading edge as the following photo.
6. Close the Roll Deck finally.
5
NOTE
Make sure to close the Roll Deck firmly until locked at the correct position.
A paper jam may occur if not locked firmly.
Place the leading
edge here.
NOTE
Slide the Cutter Knob completely until stopped at the end, or a paper jam occurs.