Kyocera FS1750 - Manual (Page 50)

2.1. Control Panel
2-5
Control Keys
The control panel keys are used to configure the printer.
☛
Settings made with these keys effect only the interface cur-
rently in use.
☛ Most of the panel functions can also be controlled by PRESCRIBE 2e commands or commands gen-
erated by application software. The printer obeys the most recently received printer settings sent
from the application software, or from the printer driver, which take priority over control panel set-
tings.
Key Function
ON LINE Switches the printer on-line and off-line.
CONTINUE 1. Depending on the message being indicated, there are cases where operation will
continue after pressing the CONTINUE key. If such a message is displayed, opera-
tion will be resumed after pressing this key. (See Table 5.3)
2. Used as the key in the mode selection function.
STACK
+
1. Selects whether printed pages are delivered to the face-down, face-up tray, or
optional sorter/stacker (if installed).
2. Lets you access the desired item or enter numeric values. In some of the control
procedures, the ( CONTINUE) and (FORM FEED) keys are used to enter or exit
the sub items.
FORM FEED 1. Prints and feeds out one page.
2. Used as the
key in the mode selection function.
CANCEL
Abandons a printing job, resets numeric values, or cancels a setting procedure.
EXIT
MODE
1. When pressed during mode selection, terminates the setting and returns to the
5HDG\ condition.
2. Used to select the emulation, font, character code set; to read an memory card
and others (See Section 2.3 and the last page in this manual.).
–
FEED
1. Enables access to the desired item or entering of numeric values. In some of the
control procedures, the ( CONTINUE) and ( FORM FEED) keys are used to enter
or exit the sub items.
2. Selects the cassette feed or MP tray feed.
ENTER
STATUS
1. Finalizes numeric values and other selections.
2. Prints a page of status information on all interfaces together (The printer must
be on-line.).