Kyocera FS1750 - Manual (Page 7)

Introduction
vi
CDRH regulations
The Center of Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration imple-
mented regulations for laser products on August 2, 1976. These regulations apply to laser products manu-
factured after August 1, 1976. Compliance is mandatory for products marketed in the United States. A label
indicating compliance with the CDRH regulations must be attached to laser products marketed in the
United States.
Ozone concentration
The printers generate ozone gas (O
3
) which may concentrate in the place of installation and cause an
unpleasant smell. To minimize concentration of ozone gas to less than 0.1 ppm, we recommend you not to
install the printer in a confined area where ventilation is blocked.
IMPORTANT SAFEGUARDS
1. Read all of these instructions and save these instructions for later use.
2. Unplug this product from the wall outlet before cleaning.
3. Do not use this product near water.
4. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious
damage to the product.
5. Slots and openings in the cabinet and the back are provided for ventilation to ensure reliable operation
of the product and to protect it from overheating, these openings must not be blocked or covered. The
openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface.
This product should never be placed near or over a radiator or heat register. This product should not be
placed in a built-in installation unless proper ventilation is provided.
6. This product is equipped with a 3-wire grounding type plug, a plug having a third (grounding) pin. This
plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to insert
the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the pur-
pose of the grounding-type plug.
7. Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on
the cord.
8. If an extension cord is used with this product, make sure that the total of the ampere ratings on the
products plugged into the extension cord do not exceed the extension cord ampere rating.
9. Never push objects of any kind into this product through cabinet slots as they may touch dangerous
voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of
any kind on the product.
10. Except as explained elsewhere in User's Manual, do not attempt to service this product yourself.
Removing covers may expose you to dangerous voltage points or other risks. Refer all servicing in those
compartments to service personnel.
11. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the
following conditions:
A—When the power cord or plug is damaged or frayed.
B—If liquid has been spilled into the product.
C—If the product has been exposed to rain or water.
D—If the product does not operate normally when the operating instructions are followed. Adjust only
those controls that are covered by the operating instructions since improper adjustment of other con-
trols may result in damage and will often require extensive work by a qualified technician to restore
the product to normal operation.
E—If the product has been dropped or the cabinet has been damaged.