Kodak V600 - Manual (Page 24)

KODAK V600 Digital Projector and KODAK V600 Zoom Digital Projector
20
Maintenance
Changing the Lamp Module
Important:The lamp in the KODAK V600 Digital Projector and the
KODAK V600 Zoom Digital Projector contains trace
amounts of mercury. Some governments require special
disposal of lamps containing mercury. Dispose of lamps in
accordance with the law and any applicable local
regulations.
The lamp module should be replaced with a certified replacement
part. To order a new lamp, contact your local dealer of KODAK
products or visit our Web site at www.kodak.com/go/projectors
After you have changed the lamp module, make sure that you reset
the lamp counter. See “To reset lamp hours” on page 17.
Warning: When replacing the lamp, be sure to turn off the power and
unplug the power cord. To avoid burns, wait 30 minutes before
opening the lamp module door.
Warning: When you open the lamp module door, be careful to not
touch the hot surfaces inside.
Warning: Do not loosen or remove any screws other than those on
the lamp module door and the lamp module. Doing so may result in
electric shock.
To replace the lamp module:
1. Turn off the projector and let the projector cool for at least 30
minutes.
The fan continues to run after the projector has been turned off.
2. Unplug the power cord from the projector.
3. Turn the projector upside down. With a flat head screw driver,
loosen but do not remove the slotted screw in the lamp module
door.
V600UserGuide.book Page 20 Tuesday, March 21, 2000 8:26 AM