Kodak V600 - Manual (Page 27)

Maintenance
23
English
Cleaning the Air Filter
To ensure proper ventilation inside your multimedia projector, the air
filter should be periodically cleaned. More frequent cleaning may be
required if you use your projector in a dusty or dirty environment.
&DXWLRQ ,I WKH DLU ILOWHU LV QRW FOHDQHG SHULRGLFDOO\ LW FDQ EHFRPH
FORJJHG ZLWK GXVW DQG SUHYHQW SURSHU YHQWLODWLRQ 7KLV
PD\ FDXVH RYHUKHDWLQJ DQG GDPDJH
Important:If the filter cannot be cleaned or becomes damaged or
torn, it should be promptly replaced with an certified
KODAK replacement part. Contact your dealer of KODAK
products for additional information or visit our Web site at
www.kodak.com/go/projectors
1. Turn off the projector and wait for the fan to stop running.
2. Unplug the projector.
3. Turn the projector on its side so that the connection panel is
facing upwards.
Note: Standing the projector on its side keeps dust from getting
inside.
4. Locate the air filter cover on the bottom of the projector and slide
the cover latch downward to remove the cover.
The air filter is attached to the inside of the air filter cover.
5. Use a soft brush to clean the air filter being careful not to tear the
filter or loosen it.
&DXWLRQ ,QVWDOOLQJ D ZHW RU GDPS DLU ILOWHU PD\ GDPDJH \RXU
SURMHFWRU
6. Replace the air filter cover on the projector. Make sure that it
clicks into place.
&DXWLRQ 1HYHU UHSODFH WKH DLU ILOWHU FRYHU ZLWKRXW WKH DLU ILOWHU
DWWDFKHG WKLV DOORZV GXVW WR JHW LQVLGH 1HYHU RSHUDWH
\RXU SURMHFWRU ZLWKRXW WKH DLU ILOWHU FRYHU LQ SODFH
'RLQJ VR PD\ GDPDJH \RXU SURMHFWRU
V600UserGuide.book Page 23 Tuesday, March 21, 2000 8:26 AM