Kodak V600 - Manual (Page 26)

KODAK V600 Digital Projector and KODAK V600 Zoom Digital Projector
22
7. Carefully place the new lamp module into the projector, with the
glass portion facing left. Make sure that it is inserted securely and
that the two holes match the two pins of the inner engine case.
Tighten the slotted screws.
8. Replace the lamp module door and tighten the screw.
9. Reset the lamp usage counter. See “To reset lamp hours” on
page 17.
Important:The only time that you should reset the counter is after you
have replaced the lamp module.
Cleaning the Projection Lens
1. Turn off the projector and allow it to cool.
2. Remove the lens cap.
3. Apply a non-abrasive camera lens cleaner to a soft, dry cloth.
&DXWLRQ $YRLG XVLQJ DQ H[FHVVLYH DPRXQW RI FDPHUD OHQV FOHDQHU
'R QRW XVH DEUDVLYH FOHDQHUV VROYHQWV RU RWKHU KDUVK
FKHPLFDOV DV WKH\ PLJKW VFUDWFK WKH OHQV 'R QRW VSLOO
DQ\ FDPHUD OHQV FOHDQHU RQ WKH H[WHULRU FDVH DV LW PD\
IDGH GHIRUP RU PHOW WKH H[WHULRU FDVH
4. Lightly wipe the cleaning cloth over the lens.
5. If you do not intend to use the projector immediately, replace the
lens cap.
Cleaning the Exterior Case
1. Turn off the projector and allow it to cool.
2. To remove dirt or dust, gently wipe the exterior case with a soft,
dry, lint-free cloth.
3. To remove stubborn dirt or stains, moisten a soft cloth with water
and a neutral detergent and gently wipe the exterior case.
&DXWLRQ 'R QRW XVH DOFRKRO EHQ]HQH WKLQQHU RU RWKHU FKHPLFDO
FOHDQHUV ZKLFK PD\ IDGH GHIRUP RU PHOW WKH H[WHULRU
FDVH 'R QRW DSSO\ WKH GHWHUJHQW VROXWLRQ WR WKH
SURMHFWRU OHQV DV LW PD\ VFUDWFK WKH OHQV
V600UserGuide.book Page 22 Tuesday, March 21, 2000 8:26 AM