Kodak V600 - Manual (Page 35)

Troubleshooting
31
English
The image source is
connected but a No Signal
message appears. • Verify that the cables are connected
correctly. See “Connecting the
Projector” on page 6.
• Verify that the proper image source is
connected and that it is selected on the
Setup tab of the menus.
• Make sure there are no bent pins in the
connectors.
• Make sure the image source is turned
on.
• Turn off everything and power up again
in the proper order. See “Turning Off the
Projector” on page 18. See “Starting the
Presentation” on page 7.
• Make sure that your laptop's external
video port is turned on. See the
computer manual for details.
MFG Mode screen appears
instead of the image. Turn off the projector and wait until the
fan stops. Turn on the projector.
Note: The MFG mode screen appears if
you press the Power button at the
same time that you plug in the power
cord. This mode should only be used
by service technicians.
Problem Cause and Solution
V600UserGuide.book Page 31 Tuesday, March 21, 2000 8:26 AM