Kathrein UFS 702sw - Manual (Page 30)

30
Antenna signal and reception parameters button
Channel menu – channel management
If necessary, use the  button to make the menu
transparent.
Use the
 and  buttons to navigate across lines
and columns and select the required channels. All selected
channels are immediately set by the receiver and displayed
in the background.
If necessary, use the
 button to make the menu
transparent.
Use the
! button (green) to delete the selected channel.
Use the # button (blue) to delete all channels in the channel
pool.
Channels that are deleted from the channel pool are only
found again when the satellite search is repeated.
Delete one channel/all channels in channel pool
The “Antenna signal” sub-menu ( ) is used to align your
parabolic antenna optimally, if required. Rotate the antenna
so that the signal strength and reception quality scales are
at their optimum.
In the event of very weak signals the signal strength scale
may even fall to “0”. In this case optimise the signal with the
scale for the reception quality.
If “Signal !” or “L” is shown in the display, a valid digital
signal is being received.
However, if “No signal” appears in the menu or “-” appears
instead of the “L” on the right-hand side of the display, then