Kathrein UFS 702sw - Manual (Page 57)

57
Receiver to receiver data transfer
Your receiver is able to receive data from another
receiver via its RJ11 port. For this, the two receivers are
connected with a null modem cable. The transmitting
receiver is the “master”, and the receiving receiver is the
“slave”.
Preparation
The master and slave are both switched on. Then the
RJ 11 ports of the two receivers are interconnected by a
zero-modem cable.
Channel list download
Master:
• Press the
 buttons simultaneously on the “master”
unit
• Press the  button to transfer the TV/Radio lists
Slave:
Do not switch the receiver off while data is being saved –
the red LED comes on (Flash IC (memory) can be
damaged)!
First “Storing” then a progress bar is displayed!
Download operating system
Only possible between two UFS 702 receivers!!!!
Master:
• Press the
 buttons simultaneously on the master
unit
• Press the button to transfer the operating system
Slave:
Do not switch the receiver off while data is being saved –
the red LED comes on (Flash IC (memory) can be
damaged)!
First “Storing” then a progress bar is displayed!