Kathrein UFS 702sw - Manual (Page 37)

37
Timer
Hinweis: If you have unintentionally deleted a line and want to
restore the original information, quit the timer menu by
pressing the
 button twice. Please note that no remote
control commands are accepted during timer recording,
to prevent OSD displays from unintentionally being
recorded over the picture. The volume is set to full during
recording. To indicate that timer recording is active, the unit‘s
channel indicator shows “r E c” if a command is received
from the remote control. Timer recording can be aborted
prematurely only with the
 = Stop key. After an abort
“End” is displayed. The unit can then be operated as
normal.
rEc
End
You can also control the timer and the video recorder by way
of VPS (Video Programme System). To do so, programme
the timer as usual in the EPG “Automatic Timer Setting”
function or directly in the “Manual Timer Setting” menu and
then press the
! button (yellow) on the selected timer line to
activate the VPS function. A (v) is displayed. Make sure the
correct VPS time is entered in the Start column. The VPS
times can also be found in many listings magazines.
When you have imported the programme you want to record
from the EPG into the timer you will automatically see the
start time, usually corresponding to the VPS time, and the
stop time. When the VPS function is active (v) the start
and stop times serve as a window within which VPS will
start the programme even if it is delayed for example. The
timer record function remains active as long as the VPS
information is being broadcast by the channel, meaning
recording may also be automatically started at an earlier
point - that is, within the preset time window, such as in the
event of a knockout in the fi rst round of a boxing match, or
later - outside the window - such as when a football match
goes into extra time.
If you programme the timer manually from the menu, do not
forget also to enter the stop time, so as to set a VPS time
window. If the programme you are recording is only short
(e.g. 15 minutes) in duration, choose a stop time to preset
an adequate time window (e.g. one to two hours). In this
way you will be sure that the VPS time window will not be
exceeded if there is a lengthy scheduling change.
VPS
“v” indicating VPS
function active
The time and date are
retrieved from the DVB
data transmitted by the
transmitter. When changing
from Summer to Winter
time and vice versa, please
adjust the “Time offset” in
the “Installation” menu.
For Central European
Summer time = {+2 h}/
For Central European Winter
time = {+1 h}
Please note that some
“exotic” channels sometimes
do not transmit the correct
time. Check the date
and time in the “Timer
Programming” menu when
programming.