Kathrein UFS 702sw - Manual (Page 51)

51
Connect your recorder and the receiver (VCR socket) using
a Scart cable. If you have a S-VHS (S-Video) recorder, from
the “Installation” menu select the “Signal paths” sub-menu
and change the selection (TV Scart VCR) so that the “YC”
signal is output at the VCR socket.
To record a programme now running, set your recorder to
record. Note that the volume on the receiver is set to full
during recording (L 20 on the 7-segment display). This is
the only way to obtain the full audio quality on subsequent
playback. Also make sure that you do not perform any
other actions on the receiver during this direct recording
process – any on-screen displays would be recorded along
with the programme.
For recording with the timer, refer to the “Timer” section.
Playback via your recorder i.e. transmission of the signal
from the VCR to the TV set, takes place automatically when
the receiver is operating or in standby. The switching voltage
from the recorder is detected by the receiver and the VCR
signal is switched through to the TV set. The 7-segment
display shows “VCR”. You can switch to the receiver
channel at any time, even without stopping playback on
your recorder. To do so press the
! button (green). To switch
back to the recorder playback, press the ! button (green)
twice.
The ! button (green) controls the TV switching voltage
(pin 8) at the TV Scart socket. The TV switching voltage is
activated when the video signal from the receiver or from
the recorder is switched to the TV set. During normal
operation, without a recorder, use the
! button (green) to
switch between the receiver channel and an additional
video signal to the TV set. This additional video signal to
the TV set might, for example, come from your existing
“analogue” antenna, from a cable connection or from a
DVD player connected directly to the TV. The display of
video signals available on the TV set is dependent on the
specifi cation of your TV set. In the above operating mode
with a recorder during playback, the
! button (green) would
thus set the video sources from the TV, the recorder and
the receiver one after the other.
Recording
Playback
Note:
Video recorder/PVR connection