Kathrein UFS 640si - Manual (Page 18)

18
Satellite and position
Use the

buttons to select the
desired satellite whose signal is to be
received by the tuner.
When you

have selected your
desired satellite, use the

buttons
to switch to the selection of the “LNB
Type”.
FIRST INSTALLATION: Simple LNB
Use the

buttons to select whether your LNB is supplied with power from the receiver (“On”) or
whether it has its own power supply (“Off”).
Test transponder
To check whether the settings that you have made are correct, use the

buttons to move to the “Test
transponder” fi eld. Use the

buttons to select the required transponder from the various ones listed.
If your settings are correct, you will see at the top right of the screen the live signal of a channel from the
currently selected transponder.
If you are not receiving a signal, check your settings again and if necessary call for expert help.
LNB settings
Use the

buttons here to select
the LNB type used in your system. The
choice is between “Universal” and “user-
defi ned”.
Universal:
No further input is required, since all
necessary frequency ranges are covered
by a universal LNB.
User-defi ned:
If you choose not to use a universal LNB,
you must here set the frequency ranges
for which your LNB was confi gured.
Use the

buttons to select
the frequency range to be changed
(low / high frequency).
Use the

buttons or the keypad
to set the exact frequency for which your
LNB was confi gured.
LNB voltage