Kathrein UFS 640si - Manual (Page 55)

55
SEARCH CHANNELS (CHANNEL SEARCH)
Press the

button You will be asked whether you wish to save the changes or not. Use the

buttons
to make the selection and confi rm the selection with the

button. If you select “Yes, save changes”, the
newly found channels will be added to the end of the channel list. Then press the button to exit the menu.
The channel list is opened on to the TV screen by pressing the

button (see also section “On-screen
displays” “Channel list TV/Radio”).
After completion of the search, you will
see the following message (example):
Make sure your reception system is aligned to the selected satellite.
Press the

button to move to the next selection item.
Transponder frequency
Use the

buttons or the keypad to select the transponder frequency on which the channel being
sought is transmitted. At the bottom right of the screen display, the receiver shows the current signal strength
and signal quality of the selected transponder.
Press the

button to move to the next selection item.
Service ID
Using the

buttons or the keypad, enter here the service ID of the channel being sought.
When you have made your settings, use the

buttons to select “Start Search” and press the

button to start scanning. You can cancel the scan at any time by pressing the button.
During the search you will see a display that shows you the progress of the search.