Kathrein UFS 640si - Manual (Page 51)

51
Satellite
Using the

buttons, select the satellite to be scanned. Make sure your reception system is aligned to
the selected satellite. You can search only one satellite at a time. If you have connected a multi-feed reception
system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you must repeat this procedure once
for each satellite. You can however start the fi rst installation again, in the course of which a channel search
of all the satellites you selected is performed.
Press the

button to move to the next selection item.
Channel Search Mode
Use the

buttons to select whether you wish to search “free & encrypted” or “only free” channels.
Press the

button to move to the next selection item.
Network Search
Use the

buttons (On/Off) to select whether a network scan should be performed. If you set the
network search to “Off”, only the factory stored transponders of the satellites you previously selected will be
searched for new as yet unlisted channels.
If you set the network scan to “On”, the transponder network enables additional transponders that have not
yet been stored to be located. They are then stored and searched for new channels in the same way as the
existing transponders.
When you have made your settings, use the

buttons to select “Start Search” and press the

button to start scanning. You can cancel the scan at any time by pressing the button. During the search
you will see the following message (example):
TV channels
found
Radio
channels found
Progression bar
Satellite with the
transponder
currently being
searched
SEARCH CHANNELS (CHANNEL SEARCH)