Liebert GXT2 - 3X1 - Manual (Page 32)

32 Chapter 1 Product Introduction
E1-20010230-C-1.0
5）Battery indicator（green）:when the battery is discharging , it is on； when it not
discharging , the indicator is off.
2. Display Information
1）UPS basic parameter information
Displays UPS' Model and present on/off state
2）operating parameters information
OUTPUT VOLT, OUTPUT FREQ, OUTPUT CURRENT, LOAD, INPUT VOLTAGE(U),
INPUT VOLTAGE(V), INPUT VOLTAGE(W), INPUT FREQ, BYPASS VOLT,
BATTERY VOLTAGE 1/CHARGING VOLT1, BATTERY VOLTAGE 2/CHARGING
VOLT 2, BATT CAPACITY CHARGING/FULL CHARGED, INTERNAL
TEMPERATURE.
3）alarm information（According to priority, from the highest to the lowest）
UPS SHUTDOWN, AUX SUPPLY failure, OUTPUT SHORT CIRCUIT, INVERTER
FAIL, RECTIFIER FAIL, OVER TEMP, OVERLOAD, CHARGER FAIL, BATTERY
FAIL, NEUTRAL FAIL, I/P PHASE FAIL, BATTERY LOW shutdown imminent and
output SWITCH FAIL.
4）failure information
Displays the recorded failure code before the last UPS shutdown at power off.
5）Configuration Settings
Chinese/English menu setup, OPERATING MODE setup, BOOST CHG SET, TEMP
COMP SET, BATT CAP SET, M/S setup M/S cycle time set up , equipment address
setup, frequency tracking range setup.
(1) Chinese/English menu settings includes:
(2) working mode settings includes:
Chinese English No change
Normal Mode ECO Mode No change