Lexmark MENUS AND MESSAGES C524 - Manual (Page 17)

Menu Groups
17
Using printer menus
Power Saver Specifies the amount of time (in
minutes) the printer waits after a job
is printed before it goes into a
reduced power state. Disabled This value does not appear unless
Energy Conserve is set to Off. See the
User’s Guide for more information.
1...240 Specifies the amount of time after a
print job before the printer goes into
Power Saver mode. (The printer may
not support the entire range of values.)
The factory default Power Saver
setting depends on the printer model.
Print the menu settings page to
determine the current Power Saver
setting. When the printer is in Power
Saver mode, it is still ready to receive
print jobs.
Select 1 to put the printer in Power
Saver mode one minute after it
finishes a print job. This uses much
less energy, but requires more warm-
up time for the printer. Select 1 if the
printer shares an electrical circuit with
room lighting and flickering lights are
noticed.
Select a high value if the printer is in
constant use. Under most
circumstances, this keeps the printer
ready to print with minimum warm-up
time. Select a value between 1 and
240 minutes if wanting a balance
between energy consumption and a
shorter warm-up period.
Alarms Controls whether the printer sounds
an alarm when the printer requires
operator intervention. Alarm Control:
Off
*Single
Continuous
Off—Printer does not sound an alarm.
Single—Printer sounds three quick
beeps.
Continuous—Printer repeats three
beeps every 10 seconds.
Cartridge Alarm:
Off
*Single
Continuous
Timeouts Specifies the amount of time (in
seconds) the printer waits to return
to the home screen, receive an end-
of-job message, or receive
additional bytes of data from the
computer.
Note: Wait Timeout is only available
when using PostScript emulation.
This menu value has no effect on
PCL emulation print jobs.
Screen Timeout:
15–300
(*30)
Disabled—Disables Screen Timeout.
15–300—Specifies the amount of time
the printer waits before returning to the
home screen.
Print Timeout:
Disabled
1–255
(*90)
Disabled—Disables Print Timeout.
1–25—Specifies the amount of time
the printer waits for an end-of-job
message before canceling the
remainder of the print job.
Note: When the timer expires, any
partially formatted page still in the
printer is printed, and other input ports
are examined to see if data exists.
Wait Timeout:
Disabled
15...65535 (*40)
Disabled—Disables Wait Timeout.
15...65535—Specifies the amount of
time the printer waits for additional
data before it cancels the job.
Menu item Purpose Values