Lexmark MENUS AND MESSAGES C524 - Manual (Page 47)

Understanding printer messages
47
Understanding printer messages
Waiting The printer has received a page of data to print, but is waiting for an End
of Job command, a Form Feed command, or additional data.
• Press to print the contents of the buffer.
• Cancel the current job.
1565 Emul Error Load Emul Option The printer automatically clears the message in 30 seconds, and then
disables the download emulator on the firmware card.
Download the correct download emulator version from the Lexmark Web
site.
31 Missing or defective <color>
cartridge Remove the specified toner cartridge, and then place it in the correct
position.
32 Replace unsupported <color>
cartridge Remove the toner cartridge, and install a supported one.
34 Incorrect media • Load the appropriate media in the selected source.
• Press
until Continue appears, and then press to clear
the message and print the job using a different paper source.
34 Short Paper • Press until Continue appears, and then press to clear
the message and continue printing.
The printer does not automatically reprint the page that prompted the
message.
• Check tray length and width guides to ensure media is properly fitted.
• Make sure the print job is requesting the correct size of media.
• Adjust the Paper Size setting for the size media being used.
If MP Feeder Size is set to Universal, make sure the media is large
enough for the formatted data.
• Cancel the current job.
35 Insufficient memory to support
Resource Save feature • Press until Continue appears, and then press to disable
Resource Save and continue printing.
• To enable Resource Save after receiving this message:
– Make sure the link buffers are set to Auto, then exit the menus to
activate the link buffer changes.
– When Ready is displayed, enable Resource Save.
• Install additional memory.
37 Insufficient memory to collate
job • Press until Continue appears, and then press to print
the portion of the job already stored and begin collating the rest of the
job.
• Cancel the current job.
37 Insufficient memory for Flash
Memory Defragment operation • Press until Continue appears, and then press to stop
the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
37 Insufficient memory, some held
jobs were deleted The printer deleted some held jobs in order to process current jobs.
Press until Continue appears, and then press to clear the
message.
37 Insufficient memory, some held
jobs were lost The printer was unable to restore some or all of the confidential or held
jobs on the hard disk.
Press until Continue appears, and then press to clear the
message.
38 Memory Full • Press until Continue appears, and then press to clear
the message and continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
Message Action