Lowrance electronic GlobalMap Baja 840C - Manual (Page 60)

52
NOTE:
If you are already located at or near the end of your trail, the arri-
val alarm will go off as soon as you hit
ENT
. Press
EXIT
to clear the
alarm and proceed.
5. Begin moving and let your GlobalMap Baja guide you.
6. When you reach your destination, be sure to cancel your navigation.
Press
MENU
|
MENU
| ↓ to
C ANCEL N AVIGATION
|
ENT
. The unit asks if you're
sure. Press ← |
ENT
.
Transfer Custom Maps and GPS Data Files
Custom Maps
Custom maps work only from the MMC card or SD card unless you
have a hard drive model. When a card containing a Custom Map File is
loaded into the unit, it automatically loads the map into memory when
the unit is turned on.
Instructions for copying Custom Map Files to an MMC are contained in
the instruction manual for your MMC card reader and MapCreate soft-
ware. For instructions on inserting an MMC into the GlobalMap Baja,
see Sec. 2, Installation/Accessories.
NOTE:
To load a Navionics ® chart, see Sec. 5 for the entry Navionics Charts.
GPS Data files
GPS Data Files contain waypoints, routes, trails and event marker
icons. Instructions for copying GPS Data Files between your computer
and an MMC are contained in the instruction manual for your MMC
card reader and MapCreate software.
GPS data automatically recorded in the unit's internal memory must
be saved to the MMC (as a GPS Data File) in order to store it on your
personal computer (If you have an HD model, these can also be saved to
the hard drive.). GPS Data Files stored on an MMC must be copied
from the card to the GlobalMap Baja's internal memory before the unit
can read them. Here's how:
1. Insert the MMC into your unit. Press
MENU
|
MENU
| ↓ to
S YSTEM
S
ETUP
|
ENT
| ↓ to
T
RANSFER
M
Y
D
ATA
|
ENT
and the dialog box below appears.