Linksys SFE2010 - Manual (Page 39)

SFE2010/SFE2010P Administration Guide 36
System Configuration
Using the Console
IPv6 Default Gateway
You can use the IPv6 Default Gateway screen to view or edit information about the IPv6 Default
Gateway.
To open this screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 2. IPv6 Address Configuration.
4. From the IPv6 Address Configuration menu, select 6. IPv6 Default Gateway.
To edit the IPv6 default gateway settings:
1. Select Edit., and then make the changes. Press the Tab key to move the cursor from one
field to the next.
NOTE: To change the state of the gateway, move the cursor to the State field, and then press
the Space Bar to toggle between ENABLE and DISABLE.
2. Press the Esc key to move the cursor to the Action list.
3. Select Execute to save your settings
4. When the Operation complete message appears, press the Esc key to move the cursor to the
Action list.