Linksys SFE2010 - Manual (Page 6)

SFE2010/SFE2010P Administration Guide 3
Getting to Know the SFE2010/SFE2010P
1-48 The Switch is equipped with 48 auto-sensing, Ethernet (802.3) network
ports, which use RJ-45 connectors. The Fast Ethernet ports support
network speeds of 10Mbps or 100Mbps. They can operate in half and full-
duplex modes. Auto-sensing technology enables each port to
automatically detect the speed of the device connected to it, and adjust
its speed and duplex accordingly.
The switch can deliver a maximum of 15.4W to a PoE port. With regular AC
power supply, there is 360W available to all PoE ports, and 280W available
with redundant power supply.
G1-G2 Ports G1-G2 are Ethernet (802.3ab) uplink ports which support network
speeds of 10Mbps, 100Mbps, and 1000Mbps.
NOTE: A switch is in stacking mode by default. In stacking mode, ports G1
and G2 are reserved for use as stacking ports.
miniGBIC1/2 The Switch provides two mini-GBIC ports. The mini-GBIC (gigabit interface
converter) port is a connection point for a mini-GBIC expansion module,
so the Switch can be uplinked via fiber to another switch. Each mini-GBIC
port provides a link to a high-speed network segment or individual
workstation at speeds of up to 1000Mbps.
Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules with the
Switch. The MGBSX1 and the MGBLH1 require fiber cabling with LC
connectors, while the MGBT1 requires a Category 5e Ethernet cable with
an RJ-45 connector.
Feature Description