Lincoln LFC 3000 - Manual (Page 8)

Page Number - 8
LFC 3000 User’s Manual
Series “A”
Form 403082
Inactive Timeout
120
In a multi I/O system without PC, this parameter must
programmed and must be the same on each I/O.
Customer Menu
Set Language
ENTER
Use Up / Down key to select the language.
LFC 3000 is a multi language system. The default
language is British English.
To change to American English, you must enter US0011.
This will also change the unit of measurement from liters to
quarts.
Customer Menu
Set Customer PIN
This prompt is used to change the Customer PIN number.
Only numerical PIN is accepted by the system.
If the Customer PIN has been forgotten, it will be necessary
to reset the system and re-configure. See Instruction
Manual, under Troubleshooting, “Lost Supervisor Pin.”
ENTER
Customer Cfg PIN
****
ENTER
Confirm PIN
****
Confirm PIN
Confirmed
System Menu
Diagnostics
As a support for the installer and after sales services, LFC
3000 provides a diagnostic report:
- the configuration for the installation parameters
- the names of the products
- the number of the users, their names and their
PIN codes
- the hoses, tanks, product’s names, displays and
corrections factors
We advise you to print this diagnostic after each installation.
Customer Menu
Configure System
ENTER
System Cfg PIN
2222
Access to the System Configuration installer level. The
factory PIN number is 2222 for the System Menu.
Customer Menu
Exit
ENTER
Return to the supervisor menu prompt. To return to the User
Screen, press ENTER again.
SYSTEM MENU
The System Configuration Menu is accessible through all
the keypads. The modified data is automatically updated at
the other keypads through the network. It is not necessary to
configure all the keypads separately. Only ticket (A&B)
printers must be configured on each keypad.
System Menu
Test Mode
ENTER
Use Up / Down key to select the test.
-Test A: test the opening/closing for each solenoid.
The test A from a keypad is only valid for the
solenoid valves connected on the I/O unit
communicating with this keypad.
-Test B: factory use only
-Test C: test to confirm the address of each large character
remote display
display address 0: random figures
display address 1: figures 000.1
display address 2: figures 000.2
Etc
-FLT FLT FLT FLT or OK OK OK OK: this test is only valid for
quadrature pulsers.
You have the possibility to test a maximum of 4 quadrature
pulsers connected on the I/O Unit.
The position of the message indicates where the position of
the pulser is.
An OK message indicates that the quadrature pulser is not
connected.
If you connect single pulsers, a FLT message will appear.
-none
System Menu
Display Allocation
The LFC 3000 offers the use of remote displays for an easy
visualization of the oil dispensed by the worker. This screen
allows you to program in the system on which display the
worker wants to visualize his dispenses. One display can
be used for multi hose reels.