Linksys 10/100 - Manual (Page 24)

EtherFast 10/100 PrintServers
Upgrading the Firmware:
The Firmware Upgrade Icon
To make sure that the PrintServer is running its most current version of
firmware, upgrade the device’s ROM chip regularly. To do so, you must be
able to access both the Internet and the PrintServer device from your comput-
er. Click on the Upgrade Firmware icon and follow the instructions on the
screen.
Exiting Bi-Admin:
The Application Exit Icon
To exit the Bi-Admin program, just click on the Exit icon.
43
Instant EtherFast ® Series
Attaching Bi-Admin to a Remote PrintServer
The Bi-Admin program can locate Linksys PrintServers on networks other
than your own, given your network is running TCP/IP across a WAN or other
network-to-network link via a router. To attach Bi-Admin to a remote Linksys
PrintServer located on a remote network, click on Init Device, then Attach.
The Add Cross Segment PrintServer window will appear. Enter the IP
address of the remote unit, then click Set. The remote PrintServer will appear
in the list of available PrintServers, allowing you to configure it.
Resetting the PrintServer
If the PrintServer seems locked up for any reason, you can reset it from the
Bi-Admin program. To reset a PrintServer, click once on the Device Name
of the PrintServer you want to reset, followed by Init Device, then Reset
Device.You can also reset it by pressing the Reset button on the left edge of
the unit, (3-Port model only), or by unplugging its power cord.
Restoring Factory Default
If you have made irreversible changes in configuration that have rendered the
PrintServer unusable, or if you simply want to start over from scratch, you
can set the PrintServer back to the default mode so that the device will oper-
ate just as it did when you purchased it. Click on Init Device, then Restore
Factory Default.
Logical Port Configuration:
Logical Port Configuration Icon
To set or change the PrintServer’s logical port settings, highlight the
PrintServer to be changed and click on the Logical Port icon (shown above).
The Logical Port Configuration window will appear. Make any changes to
the settings, and click on Save to Device when you are finished.
C Ca au uttiio on n!! Restoring Factory Default will e erra as se e A AL LL L of the work that
you have done on this unit since purchasing it.
42