Linksys 10/100 - Manual (Page 31)

EtherFast 10/100 PrintServers
57
Instant EtherFast ® Series
12. Click on the Details tab.
13. Change the Print to the LPT port number you selected in step 8 of these
instructions.
14. Click Apply, then OK to finish. Finally, reboot your PC.
N No otte e:: Linksys does not provide any technical support
for problems with NetBEUI. Consult your operating
system documentation if you need help.
56
Appendix
DHCP Support for the PrintServer
To use DHCP, which assigns non-static IP addresses, you must have a DHCP
server and DHCP management software. Otherwise, the PrintServer's IP
address will remain unknown, and connecting to it will impossible. In this
case, ignore DHCP and configure the Printserver for a static IP address as
described in previous sections.
To enable DHCP, you must run the Bi-Admin program (see page 40 for the
Bi-Admin installation). When Bi-Admin loads, it scans the network for
PrintServers and displays a list of PrintServers. Highlight the PrintServer to
be set up, enter the PrintServer’s password if one has been assigned, and click
OK.
After entering the program and selecting the PrintServer to be configured,
click on Configuration in the menu and choose TCP/IP from the drop-down
field. The TCP/IP Configuration window will appear. Select Enable to
enable DHCP, then click Save to Device. You can exit the Bi-Admin program.
To install the PrintServer driver, see page 13 for Windows 95, 98, and NT
installation.
N No otte e:: For help with the Internet Mail Printing Configuration
features, see the guide in D:\Not_supp\Manual directory
on the PrintServer Setup CD. Linksys does not provide
technical support for this option.