Linksys 10/100 - Manual (Page 43)

EtherFast 10/100 PrintServers
81
Instant EtherFast ® Series
80
11. When you finish, click on Execute Setup to save the PrintServer’s new
changes. Close down the PSCONFIG program.
12. Run Novell’s PCONSOLE program.
13. Choose Print Queue Information and press Enter.
14. A list of available print queues will appear. Press Insert.
15. Enter the name of the new queue you’d like to create and press Enter.
Repeat for each new queue you’d like to make.
16. When finished, press Esc to return to the Available Options menu.
17. Choose Print Server Information.
18. When the Print Servers window appears, type in the name of the
PrintServer you wrote down in step 4 and press Enter.
19. The PrintServer’s name will show up in the list of available print servers.
Highlight it and press Enter.
20. Select Printer Configuration and press Enter.
21. A table of configured printers will appear. The first column shows the
names of the configured printers; the second column shows the LPT ports
on the PrintServer device. Zero refers to LPT1, 1 refers to LPT2, and 2
refers to LPT3. Press Enter and fill out the information.
22. Enter a name for the printer you’re attaching to the PrintServer.
(Example: ACE)
23. Choose the Parallel or LPT port that the PrintServer should use.
24. Set Interrupts to No and leave the IRQ and Buffer entries blank.
25. Press Esc to exit. Your new printer will appear in the configured printers
list.
26. Press Esc repeatedly until the program ends.
NetWare 3.x in DOS
The instructions below explain how to establish communication between the
PrintServer unit and the rest of your NetWare 3.x network in a DOS environ-
ment. PSERVER must be loaded and configured properly on your file server
before continuing. Consult your NetWare documentation for information on
how to do this.
Manual Setup of the Print Server Mode
1. Run the PSCONFIG program, which can be found under the D:\UTILI-
TY\DOS directory on the PrintServer CD.
2. When the table of active devices appears, highlight the PrintServer device
you want to configure and press Enter.
3. Choose Set to NetWare Print Server Mode from the Available Options
menu and press Enter.
4. Make up a Print Server name and enter it. Write it down; you will need it
in a moment.
5. Skip the NDS Tree Name and NDS Context entries.
6. When you reach Master File Server, press Enter to choose from a list of
available file servers.
7. Enter a number from 1 to 255 in the Polling Queue, which is how many
seconds the PrintServer waits before polling the queue for print jobs that
might be waiting.
8. If turned on, Job Notification by Connection ID will automatically notify
the file server after a job is complete, allowing the administrator to use
PCONSOLE or other programs to monitor users’ printing.
9. Pick the frame types you want the PrintServer to support.
10. If you want to change the PrintServer’s configuration password (required
for changing the PrintServer’s internal settings), do so by clicking on
Change Password.