Linksys 10/100 - Manual (Page 28)

EtherFast 10/100 PrintServers
Problem 7: PSCONFIG or Bi-Admin shows "No Response."
Solution 7: This may be due to the following:
· The network traffic is busy now. Wait for a minute and
then try it again.
· The PrintServer is not powered on. Power it on.
· The network cable is disconnected. Check the cable.
· The node address of the PrintServer may be the same as
the node address of another device on the network.
Problem 8: QUICKSET timed out when checking if the device had
logged in to the file servers.
Solution 8: This means that the PrintServer did not log in the master
file server. It might be that the Ethernet frame types do
not match.
1. Try to find a computer the frame type of the
PrintServer using PSCONFIG or Bi-Admin.
2. Enable the PrintServer's frame type to the frame type
that the master file server uses and disable all other
frame types.
Problem 9: I cannot receive Notify message in NetWare 4.x environ
ment.
Solution 9: 1. Make sure you are a Notify member of the
PrintServer.
2. Run NetAdmin and set the name of the Default Server
to receive notification.
Problem 10: I cannot use PCONSOLE or Bi-Admin to see Printer
Status or the current server status in PrintServer
Information is showing Down in the NetWare 4.x envi-
ronment.
Solution 10: It may be that you created the print server object in
NetWare 3.x environment and used PCONSOLE in
NetWare 4.x to view the status. Try the following:
1. Ensure the PrintServer is ON.
2. Delete the print server object of the PrintServer.
3. Install the PrintServer again in NetWare 4.x NDS
environment.
51
Instant EtherFast ® Series
Problem 5: My PrintServer cannot print the jobs sent to the print
queue.
Solution 5: Try the following:
1. Check if the printer attached to the PrintServer is on-
line.
2. Check if your PrintServer is logged into the file server
(See Problem 3).
3. Check the current status of the queue. Run PCON-
SOLE and select Print Queue Information. Then select
the queue and select Current Queue Status. See if
there are three YESes. If not, set them to YES.
4. Check if the NetWare printer number is correct.
0 = parallel port 1 of the PrintServer.
1 = parallel port 2 of the PrintServer.
2 = parallel port 3 of the PrintServer
5. Check to see if the PrintServer is a static queue server
to the queue. Run PCONSOLE and select Print Server
Information. Then select Print Server Configuration
and select Queues Serviced by Printer. Then select
your desired printer and check if the queue is on the
list. If its not, insert the queue into the list by pressing
Insert key and select the queue. Then reset the
PrintServer to service the new queue.
6. The total number of queues to be serviced may be
over the limit of 56. If so, reduce the number of
queues.
Problem 6: I used the Capture command to print a job, but the job
was separated into two parts.
Solution 6: The time-out setting in Capture command may be too
short. Increase the timeout value of the
Capture command by using the option /TI=n of the Capture
command to increase the time-out value, where n is the
value of timeout.
50