Life Fitness G4 - Manual (Page 16)

15
S
TEP
13:
• Disassemble the PRESS ARM PIVOT SHAFT from the PRESS ARM (H) by removing the two 3/8 X 3/4” ALLEN
SCREWS and two 3/8” FLAT WASHERS as shown in FIGURE 13.
• Insert the PRESS ARM PIVOT SHAFT thru the PRESS ARM (H) and the PRESS ARM SUPPORT FRAME (X) and
then reassemble the 3/8 X 3/4” ALLEN SCREWS and 3/8” FLAT WASHERS to the PRESS ARM PIVOT SHAFT as
shown in FIGURE 13. (Note: Tighten this connection enough to remove excess play yet allow the PRESS ARM
to rotate freely.)
• Pull back on the SPRING PIN and rotate the PRESS ARM (H) until the SPRING PIN connects with the PRESS ARM ADJUST-
MENT (Y).
FLAT
F
IGURE
13