Life Fitness G4 - Manual (Page 20)

S
TEP
17:
• Route the LAT CABLE (AM) around one 4-1/2” PULLEY (36) and assemble the PULLEY to the
LEFT (D) and RIGHT (E) BOOM PLATES using one 3/8 X 3-3/4” BOLT (6), one LONG “L” CABLE
BRACE (S), one 1” SPACER (24) and one 3/8” SILVER LOCK NUT (19). See FIGURE 17.
• SECURELY assemble two PLASTIC SLEEVES (34) to the LEFT (D) and RIGHT (E) BOOM
PLATES using two 3/8 X 3-3/4” BOLTS (6) and two 3/8” SILVER LOCK NUTS (19) as shown in
FIGURE 17.
• Route the LAT CABLE (AM) around one 3-1/2” PULLEY (35) and assemble two DOUBLE FLOAT-
ING PULLEY PLATES (AB) to the 3-1/2” PULLEY (35) using one 3/8 X 1-3/4” BOLT (11) and one
3/8” SILVER LOCK NUT (19). See FIGURE 17. (Note: Make sure the cable runs in the
grooves of the pulleys.)
• Route the LAT CABLE (AM) over two 3-1/2” PULLEYS (35) and assemble the PULLEYS to the
LEFT (D) and RIGHT (E) BOOM PLATES using two 3/8 X 3-3/4” BOLTS (6), two SHORT “L”
CABLE BRACES (R), two 1” SPACERS (24) and two 3/8” SILVER LOCK NUTS (19). See FIG-
URE 17.
• Screw the threaded end of the LAT CABLE (AM) into the end of the HEAD PLATE ASSEMBLY
(AF). See FIGURE 17.
19
AM
36
19
F
IGURE
17