Polycom SpectraLink 1725-36203-001 - Manual (Page 23)

Customizing Your SpectraLink 8020/8030 Wireless Telephone
1725-36203-001-F.doc 23
Config menu 2nd level 3rd level 4th level 5th level 6th level
Push-to-talk † Default Channel Channel 1
….
Channel 24
Subscribed
Channels
Channel 1
Channel 2
Channel 3
….
Channel 24
PTT Audio Volume Audio Volume
„„„„„„„
PTT Tone Volume Tone Volume
„„„„„„„
PTT Vibrate
Enable/Disable
System Info Phone IP Address
Gateway IP
Address
Firmware Version
Emergency Dial ‡ Emergency Number
Emergency Name
† (SpectraLink 8030 only) Push-to-talk must be enabled by the system administrator before it can be
activated by the user. If it is not enabled, then it will not appear on the Config menu. If PTT has not been
enabled, Emergency Dial may be. Check the System Info options to determine if Emergency Dial
appears. If so, it is active.
‡ (SpectraLink 8030 only) Emergency Dial will appear if it has been enabled by the system
administrator. The Emergency Number/Name options allow you to check the number and name that
is dialed when the Emergency Dial button is pressed twice in two seconds.