Perle Systems IOLINK-PRO IOLINK-520 - Manual (Page 49)

Event Logs
A.6 — IOLINK-PRO & 520 Reference Manual
LMI discarding STATUS on link X – Enquiries not started
Generated when the bridge/router discards a Status message received from the frame relay network on a link
that the bridge/router has not yet started the Local Management Interface.
No NCP's open, tearing link down
Generated when a PPP link does not have a Network Control Protocol operating. This may be due to BCP,
IPCP, and IPXCP being disabled, or the NCP connection was not negotiated to completion.
Password accepted from <IP address>
Generated when a correct password is given for a Telnet connection. The connected Bridge/Router’s name
or IP address is specified.
Password timer has expired
Generated when a bridge/router has issued the password prompt for a Telnet connection and timed out
waiting for the password to be supplied.
Refused connection attempt from <remote site alias>
Generated when a connection attempt to a remote site is refused by that site
Remote Site <remote site alias> re-establishing due to multilink mismatch
Generated when multilink negotiated on by one end of the link and off by the other. The value for multilink
will be toggled on this device and LCP will be re-negotiated.
Remote Site <remote site alias> starting callback
Generated when an incoming CallID was matched to a remote site, and that remote site was configured for callback.
The incoming call will be rejected, and an outgoing callback to the remote site will be attempted.
Restoring boot DNLDSEG configuration
Generated upon entering Network Load Mode to initialize specific configuration information required for
retrieving new code image. Generated upon entering operational after a successful code burn into flash.
Restoring boot EEPROM configuration
Generated when restoring values in EEPROM configuration, this occurs when entering a load or operational
mode.
Running in BOOT mode
Generated when the bridge/router is starting in Boot mode. This is the mode for software upgrades. Once
the software upgrade has been successfully completed, the bridge/router restarts in Operational mode.
Running in OPERATIONAL mode
Generated when the bridge/router is starting in Operational mode. This is the mode for normal operations
of the bridge/router.
SNMP authentication failure for <IP address>
Generated when an SNMP authentication failure is detected. The SNMP message source is specified by its
IP address.