Panasonic AW-SW350E User Manual
Page 10
D
Genlock Input/BB Output Connector [GLIN/BBOUT]
In compliance with the setting of the SETUP switch
K
, either the genlock input or BB
output is selected.
Genlock input: To apply genlock to the switcher, connect this signal to the signal
generator or other device.
BB output:
At this position, the BB sync signal is output to apply genlock to a camera
or other input device by synchronizing it to the switcher. In this case, the
same signal as BBOUT
F
is output.
F
Black Burst Signal Output Connector [BBOUT]
Used to externally synchronize a input device connected to the Live Switcher. When
externally synchronizing two or more devices, distribute the black burst output to them
using a video distributor (VDA).
G
Y/C Video Output Connector [PGM Y/C OUT]
This connector delivers the Y/C signal video output which has the same function as the
video output signal
A
.
H
Auto Take External Input Jack [EXT TAKE]
Use it for external auto take by applying a contact input. The operation is the same as
when using Auto Take Switch
u
and Key Auto Switch
I
.
✽
Use an M3.5 stereo single head plug for connection with this unit.
Connect the switches as shown below.
]
Y/C Signal Input Jacks [Y/C IN 1, 2, 3, 4, 5]
Connect YC signals to these jacks in using them as video input signals.
A
Video Output Connectors [PGM OUT 1, 2]
Two sets of composite signals (BNC) consisting of the switcher's main output together with
the wipe, mix, key or other effects added are output from these output jacks.
S
Preview Output Connector [PVW OUT]
When the switcher is used for live applications, this connector enables the next operation
to be previewed. (LOOK AHEAD PREVIEW)
• While the Fader Lever is at the A-bus side and A-bus signals are output, the B-bus
signals are output to the PVW OUT Connector, and the images can be previewed.
• When the PGM OUT Connectors are in the key OFF status, the PVW OUT Connector is
set to the key ON status and the key synthesis status can be previewed.
The table below shows the correlation between the programme output and preview output
statuses.
17 (E)
ENGLISH
16 (E)
Do not connect a BNC coaxial cable to Video Signal Input Jack
p
in case of connecting
YC signals to Y/C Signal Input Jack
]
. Use either composite signals or YC signals as
video input signals.
Caution
4
2
3
1
Pin No.
Signal
1
Y GND
2
C GND
3
Y
4
C
Bus selection
Key ON/OFF
PGM OUT
A-bus selected
B-bus selected
Key ON
Key OFF
PVW OUT
B-bus output
A-bus output
Key OFF
Key ON
Due to what is involved in the signal processing, the Y/C video output
G
has a phase
which is delayed by 1 line compared with the composite video output
A
.
Caution
AUTO TAKE
KEY AUTO