Panasonic KX-BP800 - Manual (Page 15)

15
Installing Thermal Transfer Film
Using
Thermal
Transfer Film
Load thermal transfer
film in this derection
Film Cassette
Blue Label
Blue Gear
4 Load the thermal transfer film into the film
cassette.
C Load the thermal transfer film into the film
cassette so that the blue gear inserted in the
thermal transfer film is located on the blue label
side of the film cassette. Push in the direction
of the arrow until you hear all four gear shafts
click in place.
Slack Prohibited
Label
Thermal
Transfer Film
5 If the thermal transfer film is slack, take up the
slack by winding the gears on the label side of
the cassette in the direction of the arrows.
C The multi-copy/error indicator may flash
"
" if the thermal transfer film is slack.
In addition, the thermal transfer film may
wrinkle, and blank (unprinted) spots or black
streaks may appear on the copy paper.
Blue Label
Grooves
Grooves
6 Install the film cassette.
C Insert the film cassette into the printer so that
the blue gear on the cassette aligns with the
blue label on the printer and then insert the
gear shafts on both sides of the cassette into
the grooves inside the printer.
C
If the film is slack after loading the film
cassette, take up the slack in the same manner
described in step 5 while the cassette remains
loaded.
Printer Door
7 Close the printer door.
C
Securely close the printer door by using both
hands until a click is heard.
C
The " " flashing on the multi-copy/error
indicator will go out.
C
If the flashing " " does not go out even
though the printer door has been closed, this
indicates that the film cassette has not been
installed properly or that there is slack in the
thermal transfer film. Check the condition of the
film cassette and for slack in the thermal
transfer film.
Note