Panasonic KX-BP800 - Manual (Page 74)

74
Assembling the Print Board
3
Attach the print board.
■ If you are using a stand:
1. Hang the print board on the
attachment fixtures of the stand.
2. Use the two wing bolts (M5
12 mm) provided with the stand
to fasten the print board to the
lower stand attachment fixtures
as shown below.
■ If you are using a wall-
mounting kit:
1. Remove the two wing bolts and
hang the print board on the wall-
mounting fixtures supplied with
the wall-mounting kit.
(Please refer to page 82.)
2. Use the two wing bolts removed in
step 1 above to fasten the print
board to the lower wall-mounting
fixtures as shown below.
C
When mounting the print board, avoid banging it.
Such impact may break the internal fluorescent
light or cause other damage.
C
After mounting the print board, gradually apply
weight to it to make sure that the wall is strong
enough to support it.
L
R
L
R
1
2
C
The stand (KX-BP065) is available as an option.
C
The wall-mounting kit (KX-B063) is available as an
option.
Note