Panasonic KX-BP800 - Manual (Page 33)

33
Usin
g
Projector Mode
■ Basic operation flow in Projector mode
This section explains the flow of basic operations when using the Interactive Panaboard Software in the Projector
mode. We recommend trying the operations in accordance with the following steps to help you completely
understand the operations in the Projector mode.
C
For any explanations on the operations of the Projector mode, the Electronic Pen will be referred to as "Mouse"
and the projected computer screen on the Interactive Panaboard will be referred to as "Desktop".
C
Calibration
Calibration is an operation to calibrate the
position of the computer screen projected onto
the Interactive Panaboard screen to judge the
position by the Interactive Panaboard Software.
(1) Start the Interactive Panaboard
Software and select the Projector
mode. (See page 29.)
C
The calibration screen is displayed.
(2) In the sequence of upper left, upper
right, lower right and lower left, press for about two seconds for center of each four corner
position with the Electronic Pen.
C When this operation ended correctly, then the next position starts automatically.
(3) When the calibration ended correctly, there is a message telling you its finish. From this
point onward, the Electronic Pen can be used as the Mouse.
C
If recalibration is necessary, click [Calibrate] in the pop-up menu.
Note
Remark:
Place the
Electronic Pen
on this position
and depress it.
C
If you move the projector or Interactive Panaboard, the position of the computer screen projected onto the
Interactive Panaboard screen will be changed. This will result in out of position of the Electronic Pen. If this
happens, you will need to recalibrate the unit by executing [Calibrate] in the pop-up menu.
C
In the Projector mode, use the Electronic Pen with its cap on.
C Do not cover the position receiver with your hand as this may cause interactive function to stop functioning.
C
Press down firmly with the point of the Electronic Pen on the screen film until you hear a buzzing sound.
C
For precise positioning, keep the Electronic Pen perpendicularly to the Interactive Panaboard screen during
use. Inclined pen angle will cause the shift of position.