Panasonic DP-7000 - Manual (Page 13)

xi
and 85% at 95°F or below.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Sudden temperature fluctuations can affect copy
quality. Rapid heating of a cold room can cause
condensation inside the machine, directly interfering
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
with image transfer.
Do not expose the machine to direct sunlight.
Exposure to direct sunlight can adversely affect
the machine’s performance.
When moving the machine, be sure to unplug
the Power Cord from the outlet. If the machine
is moved with the Power Cord connected, it can
cause damage to the cord which could result in
fire or electric shocks.
When moving the machine, do not tilt it more
than indicated below. If tilted excessively, the
machine may fall over and cause injuries.
After the machine is installed, be sure to lock the
caster stoppers. An unlocked machine may fall
over or slide and cause injuries.
The machine is capable of operating normally
within the following recommended environmental
limits. The temperature range is 50°-95°F,
humidity range is 15-85% (without condensation).
The humidity should be 47.5% or below at 95°F,
Two power specifications are listed below. The
specifications that apply to your machine
depend on your machine configuration. Connect
the power plug only to a properly rated power
outlet. Otherwise, it can cause fire or electric
shocks. If in doubt, contact your local
authorized Panasonic service representative.
Rated voltage: 120 VAC
Rated frequency: 60 Hz
Rated voltage: 220 - 240 VAC
Rated frequency: 50/60 Hz
Power Requirements and Ground Connection
Never use multi-plug adaptors to plug multiple
power plugs in the same outlet. Be sure to
operate the machine on a single-use
receptacle. Multiple connectors can cause
the outlet to overheat and cause fire.
Ensure that the plug connection is free of dust.
In a damp environment, a contaminated
connector can draw a non-negligible amount of
current that can generate heat and eventually
cause a fire over an extended period of time.
Always use the Power Cord provided with your
machine. When an extension Power Cord is
required, always use a properly rated cord. In USA,
it is 125 V/15 A. In other countries, contact your
local authorized Panasonic service representative.
If you use a cord with an unspecified current rating,
the machine or plug may emit smoke or become
hot to the touch externally.
Other Precautions